|
The thermal design power (TDP), sometimes called thermal design point, is the maximum amount of heat generated by the CPU that the cooling system in a computer is required to dissipate in typical operation. Rather than specifying CPU's real power dissipation, TDP serves as the nominal value for designing CPU cooling systems. The TDP is typically not the largest amount of heat the CPU could ever generate (peak power), such as by running a power virus, but rather the maximum amount of heat that it would generate when running "real applications." This ensures the computer will be able to handle essentially all applications without exceeding its thermal envelope, or requiring a cooling system for the maximum theoretical power (which would cost more but in favor of extra headroom for processing power). Some sources state that the peak power for a microprocessor is usually 1.5 times the TDP rating. However, the TDP is a conventional figure while its measurement methodology has been the subject of controversy. In particular, until around 2006 AMD used to report the maximum power draw of its processors as TDP, but Intel changed this practice with the introduction of its Conroe family of processors. A similar but more recent controversy has involved the power TDP measurements of some Ivy Bridge Y-series processors, with which Intel has introduced a new metric called ''scenario design power'' (SDP). == Overview == The TDP of a CPU has been underestimated in some cases, leading to certain real applications (typically strenuous, such as video encoding or games) causing the CPU to exceed its specified TDP and resulting in overloading the computer's cooling system. In this case, CPUs either cause a system failure (a "therm-trip") or throttle their speed down. Most modern processors will cause a therm-trip only upon a catastrophic cooling failure, such as a no longer operational fan or an incorrectly mounted heatsink. For example, a laptop's CPU cooling system may be designed for a 20 W TDP, which means that it can dissipate up to 20 watts of heat without exceeding the maximum junction temperature for the laptop's CPU. A cooling system can do this using an active cooling method (e.g. forced convection) such as a fan, or any of the three passive cooling methods: convection, thermal radiation or conduction. Typically, a combination of these methods is used. Since safety margins and the definition of what constitutes a real application vary among manufacturers, TDP values between different manufacturers cannot be accurately compared. For example, while a processor with a TDP of 100 W will almost certainly use more power at full load than a processor with a 10 W TDP from the same manufacturer, it may or may not use more power than a processor from a different manufacturer that has a 90 W TDP. Additionally, TDPs are often specified for families of processors, with the low-end models usually using significantly less power than those at the high end of the family. The dynamic power consumed by a switching circuit is approximately proportional to the square of the voltage: : where is capacitance, is frequency, and is voltage. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Thermal design power」の詳細全文を読む スポンサード リンク
|